Highly Scalable Silicon Photonic Switches Based on Waveguide Crossbar with Movable Waveguide Couplers

Fast opticalcircuitswitches (OCS) having a large number of ports can significantly enhance the performance and the efficiency of modern data centers by actively rearranging network patternsCommercially available optical switches typically operate with the use of moving mirror arrays. These switches can have port countexceeding 100x100 and insertion losses lower than afew dBs. However, their switching speedare typically tensofmilliseconds which limits their applications inhighly dynamic traffic patternsMoreover, the movingmirrorbased optical switches make use offreespace optics that requires manual assembly andas a result, the costare high.
Recently, optical switches based on silicon photonics technology have been designed and builtSilicon photonics technology provides an attractive platform foroptical switches. In them, light is tightly confined in silicon waveguidedue to its high refractive index.The tight confinement allows dense integrations of switch components. By leveraging complementarymetaloxidesemiconductor (CMOS) fabrication processes, large scale integrated optical circuits can be made at relatively low cost in high volume. Silicon photonic switches with microsecond or nanosecond response timehave been demonstrated using thermooptic effectsor electrooptic effects, and silicon photonic switches with integrated CMOS driving circuits have been demonstrated. However, the demonstrations were mostly limited to a small number of ports. This limitation is mainly due to the switch architecture usedwhich scales port counts by connecting 2x2 switching units serially. In this architecture, switching loss increases rapidly as the number of connected units increases.
In this dissertation, I investigate a new architecture for silicon photonic switches that is highly scalable. The architecture is based on a waveguide crossbar having moving waveguide couplerthatc onfigure light paths, so that there is only one switching stage for any given light path regardless of port count. As a result, switching loss does not accumulate as port count increases. I compare scaling prospects for this architecture with those of previously designed silicon-photonic-switch architectures.
I then investigate three implementations of silicon-photonic-switches that use the proposed architecture. First, the experimental demonstration of a 50x50 silicon photonic switchwhich I identify as Generation-A (Gen-A)is shown. In Gen-Aa vertically moving directional coupler is designed for switching operations, and an electrostatic-cantilever-actuator is designed to move the directional coupler. A waveguide-crossing with ultra-low-optical-loss is designed to minimize crossbar losses. The 50x50 Gen-Aswitch is monolithically integrated in a chip with less than 9 x 9 mm^2of area. The response time of theGen-Aswitch is 2.5 μs, and its actuation voltage is 14 V.
Second, a silicon-photonic-switch identified as Gen-B that provides point-to-multipoint connections is researched.  Laterally moving directional couplers are designed for more precise switching operation than Gen-A. The laterally moving directional couplersin Gen-B directoptical power only to receivers that are meant to subscribe to the sender, unlike broadcast-and-select type switches which waste optical power by sending it to all receivers. The Gen-B switch is demonstrated in 1-to-2 and 1-to-4 switching operations. The response time of the Gen-B switch is 9.6 μs, and its actuation voltage is 10 V.
Finally I present a third case(Gen-C), a design for a silicon-photonic-switch that can process signals having various incoming polarizations is shown. In Gen-C, waveguides are designed to support both TE-and TM-modes, and the two-layer waveguide crossbar is used to eliminate completely any waveguide-crossing losses. The adiabatically tapered waveguide couplers in Gen-Care designed to switch both TE-and TM-modes at the same time while Polarization-Dependent-Loss (PDL) is held to0.5dB. The single-stage and two-stage parallel-plate-type electrostatic actuators in Gen-C are specifically designed for digital switching operation.
Publication date: 
December 31, 2016
Publication type: 
Ph.D. Dissertation
Han, S. (2016). Highly Scalable Silicon Photonic Switches Based on Waveguide Crossbar with Movable Waveguide Couplers. United States: University of California, Berkeley.

*Only registered BSAC Industrial Members may view project materials & publications. Click here to request member-only access.